Voodoo-lab Ground Control(Original Version 2) Manual de usuario descargar pdf (Pagina 21)

DIGITAL MUSIC CORPORATION

Assigning MIDI Program Changes

¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯¯

Use the [SELECT] buttons to choose each of your MIDI

controlled devices. You will see the names of each device that

you entered in Setup mode. It will look something like:

TRIAXIS - 18

↑ ↑

Device Name Program Number

Now enter the number of the program you want for each

device. You can access any program from 0 to 128. For

example:

• For program 6, press [0] [6]

• For program 36, press [3] [6]

• For program 112, press [1] [1] [2]

Notice that there is a slight delay when you select programs 10,

11, or 12. This is because the Ground Control is waiting for a

third digit in case you wanted programs 100 through 128.

Note: The Ground Control automatically filters redundant

program changes when Presets are recalled, to avoid

audible glitches.

You can also instruct the Ground Control to not send a MIDI

Program Change. How you do this depends on whether your

device numbers programs from 0 to 127, or from 1 to 128 (see

"Start Number" on page 11). To not send a MIDI Program

Change, do one of the following:

• If the device starts at 1, then choose program 0 by pressing

[0] [0].

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

Sin comentarios

Voodoo-lab Ground Control(Original Version 2) Manual de usuario Pagina 21